Search results

Its called Chromaveil, its printed on a fine polyester cloth,it can be used in a mold or as an overlay, conforms to tight contours and compound curves,designs are limited but for $120.00 a yard they will print anything you want, think of it as a clear coated UV stable wrap...

Good thing I don't believe in that psychology crap then I reckon

Bahhhhhh you just want to hold his hose for him lol

My parts book says they are both 160mm and they interchange

Pull the head inspect the damage report back your motor, she be dead

The shaft bearings are sealed greased bearings, no way to grease them after the seals are installed, all you are greasing is the seals and if you grease them too much you run the risk of blowing out a seal, one shot of grease every year isn't going to hurt anything, if you get carried away you...

I tuned in the Blackjack carb on 98gti's ski a month or so back, without a doubt the easiest carb I have ever tuned in on a modded ski ,bar none.

Scouted the location yesterday, I counted six trucks with trailers there, one boat put in and one pulled out while I was there, location has a small covered pavillion with two picnic tables and bathroom facilities which seemed fairly clean. Water level is good, water temp was fine, I wore...

Ok in the second pic two vents do go there, one is for the battery, the other for the fuel tank Third pic thats where the choke cable went fourth pic a hose from the primer pump that replaced the choke system, you are going to get another of these and hook it up fifth pic overheat sensor...

Going to scout the Alex City site and see what kind of traffic is there this time of year, also need to make damn sure there are no Bass tournaments there next week, its that time of year I am afraid. I will report back later tonight.

Mmmmmmmmmmm koolaid !

BTW I have a 650 pump tunnel I pulled out of my X2 for sale cheap if you want it.

Whatever Matt, last time we had two Alex City police cars and the water patrol show up, you go on ahead.

I just glued some formica down with this, how long should I way before using my counter top?

Welcome to the X, the epicenter of BS

I need to measure my OP nozzle and see what size it is.

That place is dirt cheap on heat shrink, they even have a closeout section lol

I have had a few issues over the years ,most were a long long time ago, no real horror stories to tell, but then I have installed an a$$load of engines and crankshafts over the last 12 years. I prefer to build the engine myself if the case are good, that way I get the say so on the piston mfg...

Think about it, whats your point of contact between the lug and the wire when you crimp it, now whats the contact are on a soldered on lug, the solder fuses all the smaller strands together and puts them in direct contact with the lug, the only way to do it better would be to find adhesive lined...

Thats correct I don't crimp it at all.