Other Nice deal on a beach cart

[Matt_E]

I don't have any though.
First I need to cough up the money for a 4.5mm Allen wrench to get the wheels off. I don't have one yet.

 

[WaveDemon]

4.5? that's silly.

 

[Matt_E]

Maybe I'll take a five and massage it down to 4.5. Now that would be sketch.

 

[AtomicPunk]

dont need 2 part, just use some of that $6 slime stuff...

 

[Matt_E]

I don't think tire slime will fix the four inch dry-rot cracks in the side walls.

 

[WaveDemon]

Maybe I'll take a five and massage it down to 4.5. Now that would be sketch.

no, use a 5 and a hammer.

 

[Matt_E]

If I had a hammer....

 

[WaveDemon]

If I had a hammer....

if you truly were sketch you would know anything can be a hammer. grab a rock or an adjustable wrench.

 

[Matt_E]

I am ashamed to admit that I have two actual hammers. (Plus a rubber mallet!)

 

[WaveDemon]

I am ashamed to admit that I have two actual hammers. (Plus a rubber mallet!)

I hope they're claw hammers.

 

[Matt_E]

YES!

Most of the time I'm too lazy to go get the hammer and I'll use my 1/2 ratchet instead.

 

[WaveDemon]

1/2" ratchets are GREAT hammers.

 

[Matt_E]

They have just enough heft.
Channel locks are also an acceptable substitute.

 

[Big Kahuna]

everyone I have seen has that joint in the center, believe it is suppose to be broken down for travel.

 

[Matt_E]

Yes. It breaks down very nicely.
It's too bad I still cannot fit a ski and the beach cart in the back of my Ranger. I would like to not use a trailer all the time

 

[WaveDemon]

.
Channel locks are also an acceptable substitute.

now you're taking it too far.

 

[Big Kahuna]

Yes. It breaks down very nicely.
It's too bad I still cannot fit a ski and the beach cart in the back of my Ranger. I would like to not use a trailer all the time

Remove the pole, put the ski on one side of the bed, Put the wheels and bunk section on the other side, put the bars down the side (Bottom of the bed).

 

[Matt_E]

Hummmmm....I'll give that a try once I got everything ready.

 

[Matt_E]

now you're taking it too far.

Sometimes the 1/2 ratchet is too far away and the 3/8 ratchet just isn't cutting it.
Besides, my father in law is an electrician - channel locks are electrician multitools. I think it's actually a federal law that electricians are legally allowed only channel locks.

 

[OCD Solutions]

Your thinking of linesman pliers, lol. I could build a house with mine.