Ported 760 jetting advise

[bkspeedwerks]

Looking for a rough starting point for jetting the following build. I know alot of guys have similar setups. thanks


Ported 760 (cylinder was machined to adjust port timing)
ported b pipe
zeeltronics
oem 44s with crossover filled
stock flame arrestor with 1 screen

 

[maxboost]

125 low
115 high
24 psi pop off
Should be a some what close starting point.

This has recently been discussed in the general section if you want to check out that thread as well

What kind of porting was done to your cylinder? I’m guessing someone cut the bottom of it some to lower port timing? Just curious