FX-1 Hood liner

Looking for advice on making a new fx1 hood liner. I removed the liner because it was sagging from heat and the foam blocks inside were loose and blocking air intake. I had to heat it up hot to get the glue to separate and left the liner unable to reuse. I've got minor fiberglass experience doing footholds and refoaming tray. I'm not sure how to make a liner though.
 
I'm ok with that. I was more or less looking for a solid way of recreating the liner with fiberglass I think. I have my own ideas of making a liner but I assume someone has a better way. I'm thinking I'll foam fill it and sand to needs then lay foil down over the foam to lay my glass on to, then I can remove the liner after dried and remove the foam base underneath. Then install the liner with 5200?
 
So i got this liner made just in time for Daytona and I figured I'd share some pics.1513998895737.jpg 1514057177925.jpg 1514428250559.jpg 1514512168463.jpg 1514741751747.jpg KIMG0386.JPG It turned out pretty good I think. If I had to do it again I would have used 4200 instead of 5200.
 

Attachments

  • 1513861280464.jpg
    1513861280464.jpg
    29.9 KB · Views: 16
Top Bottom