Hi Guys,
I am looking at installing the following blowsion scupper valve https://www.blowsion.com/products/hull-components/bilge/one-way-valves/blowsion-cas-billet-aluminum-one-way-valve-scupper . Does anyone have any pictures and or tips that they could recommend.
Is it required to remove...
Hi Guys,
Just looking to get some clarification between the difference that unleaded vs leaded fuel will have on your engine. I am currently running a 2013 superjet with aftermarket high compression head usually using anything from 93-96 octane by diluting leaded bases 100+ pro crate high...
Hey guys,
I am in the middle of installing my factory pipe and I need to know which other hose to connect to the bottom of the manifold. Do I simply split the one line that is coming in from the jet pump right next to the shaft? Like disconnect the existing OEM t and re-use it.??? Need some...
Hi Guys,
I took a ride with my ski today and I realized that I forgot to synchronize the carburetors. I built a synchronizing tool using water bottles and plastic tubes linking to the carb primer nipples. I am not sure if I should be running the ski in water while doing this or if I can simply...
Hi guys,
Just a few questions in regards to a few modifications I will be undertaking.
1- I would like to modify my stock handle by cutting 4" shorter than its original length. I'm guessing the easiest way to do this is by removing the rivets at the base of the handle near the mounting...
Can anyone provide a picture of their current wiring diagram scheme? I have two male connectors which are not connected to anything at the moment. one is from the stator and the other is from the start stop switch. One end is from the MSD black eyelet and female end connector that connects to...
Looking to purchase a new intake grate. I've been looking at the blouson aluminum SJ intake grate or the Riva Tri Loader Intake Grate. Any other options I should be considering? Does anyone have feedback on a similar grate, or on any others that I should take a look at
Hi Guys,
I am wondering if it is really worth the 300$ to spend in order to get a new water box, and does it really make a big difference? Does anyone have any info.
Hi guys,
I am looking at buying the two piece blowsion cylinder head. I have a question in regards to the stock thermo sensor, where will be installed on the blowsion head???
Hi guys I started to get my ski ready for the foothold installation. I sanded down the tray with 80 grit and I and working on the sides. I was wondering if anyone had any advice of the distances which the the foot hold must be install lets say from the front of the tray or something. I will...
Hi guys, I'm fairly new to this sport, and I am deciding to overhaul my new 2013 Yamaha Superjet. I am open to advise and my first question would be the following: do I require to remove the engine in order to install the bilge system as close to the shaft as possible? I noticed that i may be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.