Search results

I put 4 hours on an engine, pulled the front cover, and ripped the brand new gasket which is really annoying. I know I should have had a thin layer of grease on it but this event reminded me....wasn't someone supposed to be working on an Oring billet front cover? Maybe it was in the 70 page...

I recently bought a torrent 155 so figured why not go ahead and upgrade my trim system while I'm at it. I was leaning towards the raptor kit, but figured I would get some opinions to make sure I don't change my mind. I currently have the thrust pro and while it's served me well, I know better...

Is there a target temperature for a PFP chamber when running wet? You have the temp strip on the chamber, but how accurate is it since the chamber is jacketed and the heat has to transfer through? I’m running a 70 jet right now and I don’t think I’ve ever seen my temp strip go past 122 degrees...

Looking for a head for an 1105. I do not care which one it is as it’ll be temporary until I get a new one.

Non tapered 90-07 SJ driveshaft. Measures 26&3/16”. SOLD RRP 50mm riser bars. Barely used! SOLD Lightened 61x flywheel. No clue who did it but it weighs about 2lb 14oz. SOLD

Factory Pipe limited Chamber was only used for 2 months. Head pipe in great shape. All screws turn no problem. Manifold is tapped for dual cooling. 1 helicoil in the manifold. Both mani and head pipe opened to about 49mm. SOLD Jetmaniac waterbox Awesome waterbox! Great sound, super light. SOLD...

This is a spare kit I put together. Includes everything you need to bolt on and go aside from an oil block off plate. All parts are OEM and the flywheel has the third lump removed already. CDI is brand new. I installed the kit on my ski for test purposes only. Fires up and runs as it should...

Stripped the splines on my driveshaft and midshaft. Not sure the cause yet as I just now pulled the pump. Any suggestions are welcome. Does this look like enough spline engagement?

Was riding yesterday and thought I broke my cable. Looked down and noticed the screw holding the lever together was gone. Little bit of safety wire had me riding the rest of the day. Anyways, it seems to be an M4 - .7 bolt that used to be there. What I’m wondering is if there was a bushing or...

Looking for a straight fat (1 1/8”) handlebar. Needs to be black. Prefer RRP but open to others.

I just want to talk this one out to make sure my thinking is correct. I’m going to align a 155 pump in a KDX. The engine is set back an inch but still uses a SJ midshaft so the shaft just gets pressed into the housing further. So this means the driveshaft doesn’t even protrude inside the hull so...

Limited chamber that I no longer need. $200 plus shipping.

Looking for a +2 intake grate in good condition. Thanks!