Search results

  1. nightrider05

    Super Jet Worn through ground wire cause running issue?

    Update for anyone following. I wasn't happy with the one coil I had put in since its resistance was reading 24k(some specs say thats ok, others I found say not ok) so I put in one that had 4.5k resistance. I also rewired ebox following a diagram. Ski ran great for 5 hours! But then a new...
  2. nightrider05

    Super Jet Worn through ground wire cause running issue?

    I also verified that the flywheel key was not sheered when flywheel was removed to replace stator. Dual cooling fitting was broken on the pump, so the exhaust was also running a tad hot. Did melt the sheathing off the start stop switch harness but not into the wiring. So much poop to fix. I...
  3. nightrider05

    Super Jet Worn through ground wire cause running issue?

    Thanks for the reply. Carbs were the first thing I looked at. It has a ported TLR 735cc motor with dual 44s. I noticed throttle shafts were sloppy. I had a mint dual 44 set on the shelf so I swapped everything over and rebuilt with Mikuni kits. Popoff was very high..over 30psi. I lowered that...
  4. nightrider05

    Super Jet Worn through ground wire cause running issue?

    Thanks for checking. I've read some places say 13.5+ which was throwing me off. Sent from my SM-G900V using Tapatalk
  5. nightrider05

    Super Jet Worn through ground wire cause running issue?

    If someone could confirm what the voltage at battery should be while running, that would be helpful. My fx-1 is around the same number(12.9 while running) Sent from my SM-G900V using Tapatalk
  6. nightrider05

    Super Jet Worn through ground wire cause running issue?

    I was doubting this would be the issue, but it was worth a shot. Either way it needed to be fixed. Ski sounds "Ok" on the trailer..once under a load it falls flat on its face off idle. It was running great...did a decent wide open run and then it acted like it fouled a plug. It had done this...
  7. nightrider05

    Super Jet Worn through ground wire cause running issue?

    Meant to say "run crappy"...not "not run crappy"...it won't let me edit it on tapatalk. Sent from my SM-G900V using Tapatalk
  8. nightrider05

    Super Jet Worn through ground wire cause running issue?

    I can go in to more detail later, but my ski went from running great, to acting like it is in limp mode. I have swapped nearly every electrical component chasing this issue down, and just came across this worn through ground wire. So can a worn through ground wire cause ski to not run...
  9. nightrider05

    Used OEM Kawasaki 750 Big Pin Crank- $200

    Asking $200 plus shipping OBO for an OEM Kawasaki 750 Big Pin crank. Bearings are smooth and no excessive rod play. PM if interested. Should be around $25-30 shipping in US. Sent from my SM-G900V using Tapatalk
  10. nightrider05

    Anyone sell a block off kit for leak down testing?

    I'm really surprised nobody makes a kit. I have looked many times with no luck. It would be a cookie cutter item for anyone with a laser to cut out. Sent from my SM-G900V using Tapatalk
  11. nightrider05

    Need advice to pass to friend with a worn out 97 WV1100

    It also never hurts to simply list the ski as is for more than you would think it's worth, but be honest in your ad. People love projects and I often sell project skis much faster than water ready ones. Sent from my SM-G900V using Tapatalk
  12. nightrider05

    Need advice to pass to friend with a worn out 97 WV1100

    It all depends on how much your friend needs out of it. If he is wanting to recoup a large chunk of money, fixing and selling is the only option. Selling as is, I would expect only 300 or so out of the ski. Parting out will bring you much more, but the big ticket item (motor) is shot. In...
  13. nightrider05

    Yamabro

    Great guy to deal with. Good pricing, fast shipment and part was exactly as described. Thanks again! Sent from my SM-G900V using Tapatalk
  14. nightrider05

    WTB : Yamaha Wave Venture Bar Pad

    Found! Sent from my SM-G900V using Tapatalk
  15. nightrider05

    WTB : Yamaha Wave Venture Bar Pad

    Looking for a good condition Yamaha Wave Venture Bar Pad. Purple or Teal green will work. I'm sure someone out here is using one for a donor! PM me please. Sent from my SM-G900V using Tapatalk
  16. nightrider05

    Fyrhazard- Great seller

    Bought a Hazard bracket and it arrived quickly. Great looking part, fantastic price, and very good communication from seller. Thanks again!
  17. nightrider05

    Advent ignition for Superjet

    I have a tempest T3 for a superjet..however the ski had been sitting for a while and now wants to backfire with the T3. I installed an enhancer and the backfire went away. I am assuming the T3 has issues, but I honestly don't know. Maybe it could be checked out or repaired?
  18. nightrider05

    Want to Buy Aftermarket SN Superjet Pole or SN to RN Bracket

    Thanks. I am going to hold out a while for a squarenose AC pole Sent from my SM-G900V using Tapatalk
  19. nightrider05

    Want to Buy Aftermarket SN Superjet Pole or SN to RN Bracket

    Looking for an aftermarket Pole option for my SN superjet. This could be a SN AC Racing aluminum pole(want one with zero dents), or a conversion bracket (hazard or watcon style) to convert from SN to RN pole. I will consider a used RRP or KP pole as well if a bracket is available for them to...
  20. nightrider05

    Pellet grills/smokers

    Interested in hearing some responses. I plan to buy one very soon. I was looking on ebay and found multiple brands I had never heard of that had decent reviews. Would be nice to figure out which ones to avoid.
Top Bottom