Recent content by Ken23

I drill 2 holes on each side of the tunnel 1 high to allow excessive foam to escape from and a lower hole to pour the foam into. It is a good idea to line the engine compartment with plastic just in case you over do it with the foam.

The problem with the sheets of polystyrene is you have to cut open the tray to install it. Which is fine if you are removing the old water soaked foam, but if you are adding flotation to a hull for the first time you are better off drilling two holes in the engine compartment wall standing the...

I have been looking into using the 2 part foam packets they now have out for construction, it is used for setting post ETC. Everything I have read says it will never absorb water. One brand out is Sika Polyurethane Fence Post Mix. I have reached out to some of the companies that manufacture...

Hello, I need a Mid shaft assembly for a Helium build with a PHP engine. Please let me know if you have one. Thank You

Is this pipe from a 750 Kawasaki?

If you do decide to part the ski out I would be interested in the exhaust system.

Understood. Enjoy the ski, Have fun

Is your compression high enough to be running 113 octane? The compression would have to be well over 200 psi per cylinder to run that gas. If your compression is under 200 try running 91 octane free at 40 to 1. I think you would be shocked by the increase in power and love the cost savings

It was great of the other 2 competitors in the Daytona Cherry Popper competition to come over and help.

What were you asking for the Craigs listing?

I am not sure what size the pump is. It is the stock pump that came with a 1995 Kawasaki 750 SXI. Skat-Trak rebuilt it, replaced the impeller and bored it.

I would like to use a Yamaha pump but like I said too much money invested not to put it to get use.

Thank You I will look into both replies. If I make new bed plates will the Kawasaki pump fit many after market hulls?

A couple years ago I invested way too much money into the engine and pump for my Kawasaki 750 SXI. I would like to put this setup in a after market hull, obviously it would not do well in a Free Style Hull, but I think it would perform well in a surf hull. It appears that some BOB hulls will...

I am surprised all the bad publicity TWANGLED receives I owned a Havoc hybrid that weighed 72 pounds when I picked it up and have known others that have had Backie Chans none of us ever had any issues. I was at a surf ride in Kenosha WI. earlier this year and there was a Havoc their that...