2019 Rickter Edge FS Build

headshock

still doin it
Location
Norcal
Still buying time: Finally completed the exhaust port matching and polishing then gave the TPE some new knockers. Warning these pics are explicit NSFW - a little TPE porn ;-)20190320_160209.jpg20190320_160214.jpg20190320_160233.jpg20190320_160954.jpg20190320_164155.jpg20190320_171015.jpg20190320_175906.jpg20190320_215636.jpg20190320_215645.jpg20190320_222249.jpg
 
Last edited:

headshock

still doin it
Location
Norcal
Passing time, still waiting, any day now. I was able to register this as a 2019 Rickter without any problems. Hope to hit the water soon.Resized_20190515_151835_661_1557971082217.jpeg
 
Last edited:

headshock

still doin it
Location
Norcal
Turf is standard diamond cut. I ordered extra padding, front sponsors, and ninja footholds as options with the FS build.
 

headshock

still doin it
Location
Norcal
The first big issue I just ran into is when trying to align the engine to the midshaft. The engine sits 5.8 mm to high in the front and the rear. I am running the OEM motor mounts 6R7-44517-00-8S. Starting to think this hull was manufactured incorrectly. We have tried bringing the front of the engine up but that just opens the gap at the bottom. Has anyone else run into issues with Rickter Hulls? Normally the engine is low and I can add shims to align it, with it too high that's is a whole different type of problem.thumbnail.jpg
 
Last edited:
Top Bottom