putting 155pump in blaster

[pjsc823]

has anyone tried to put the 155 pump in a blaster?

[NelsonLt1]

I have seen pictures (I may have one saved on my other computer, if I do I will post it later). I am thinking about doing it to my 1100 b1 after I do some testing w/ the stock pump.

Luke

[WaveDemon]

I think it's been determined that the 144 pump is superior on smaller ski's.

[NelsonLt1]

Here are a few pictures a guy sent me of his 155 he put in a 1200 blaster.
Demon, what kind of HP will the 144 handle? I'm trying to figure out what prop to start with on mine, any suggestions?

[WaveDemon]

I know that WDK with his 1200 couldn't get the 155 pump to work in a sj.

[pjsc823]

I am testing a 16/22 swirl in my 951 b1 I will let you know how it goes.

[CARBONX2]

You have to increase the intake gullet size on the hull to make a bigger pump work. bigger gullet gives better acceleration, smaller gullet gives better top-end by the pump not becoming overstuffed.

[SUPERJET-113]

That makes sense.
My B2(155mm pump) that i ride my kid on is a regular OEM 760 but it has dual 38's and you can literally hit the gas and it leaps out of the water like a stand up. It has TONs of low end hit. Its a all stock 64X just running the dual 38s and not the OEM 44s that come stock on the B2.

If you made a huge intake cavity like CARBONX2 says on a SJ or whatever hull i think it would hit like a freight train in the low end area and launch.

[pjsc823]

I am trying a 148mm 16/21 swirl using a 148mm wear ring with 144mm stator section. should be ready for testing wednesday. pump is finished and installed just have to finish some little odds and ends..

[NelsonLt1]

please let me know how that works.

I went ahead and ordered one of the aluminum 155 pump shoes from Jeff at waterdawg since I was getting a new razor hoods from him :bigok:. But fist I'm going to try a few different props I have before I make the jump to the 155.

[seatsR4toilets]

Yeah, give us an update on that.