sx-r ???

[hotveedub]

? 4 evrey sxr w mods I have been on a SJ for 7 years and whored myself to a sx-r so my ? I bought a bunch of stuuf but I am a little worried of how to install the advanced timing and I dont want to screa it up
I also am rejetting,pipe,impeller,new pole, and the cyclone foot hold
I just need to know about the timing and maybe the jetting
thanks for the help ps I am trying to on the water on sunday

[Proformance1]

if you are installing timing adv I assume you have an 03? If not just unplug the sensor and loop it, should be supplied if you bought a Factory Pipe. That advances the timing electronically.

[hotveedub]

thank you I kind of figured it wasnt that hard to install thanks again. anything about the jets?

[vitalikol]

jetting depend on setup you running: pipe,pump,head,

[hotveedub]

I am running v force 3 reeds and intakes spaceres impeller dry pipe advance timing not doing heads yet I also did cyclone footholds and the new pole I am looking to find out what the setting for the lower and uper jetts should be and I am located in texas fresh water only with this ski the about 600' above sea level thanks for everyone help>>>

[vitalikol]

give a call to jetworks

[Millertime]

dry pipe with no girdled head is sketchy. you can find used R&D heads for dirt cheap.

[Proformance1]

dry pipe, I'm out check on PWC today. Most SXR guys here run wet pipes.