x2 hull weight

[cattledog]

was searching and could not find much info how much does a x2 hull weigh, on another post someone said around 170, anybody else, and how to weigh it

[crab]

was searching and could not find much info how much does a x2 hull weigh, on another post someone said around 170, anybody else, and how to weigh itMine was around 116 before reinforcment.

[cattledog]

how did u weigh it

[crab]

how did u weigh it
Batroom scale.

[madscientist]

bat room scale, kept in the bat cave.

doggy dog booked your room yet?

[Project Ski]

I came in aroudn teh same as crab. Maybe 110-112 total. Hull and hood.

Bathroom scale used

[cattledog]

thanks i weighed mine and it was around 125lbs with tubbies on handlebars accusteer braces and all hardware still on ski , like motor mounts and hull braces

[cattledog]

Mine was around 116 before reinforcment.
was that with hood on crab, i am trying to find the weight just to see how much i am waterlogged

[crab]

was that with hood on crab, i am trying to find the weight just to see how much i am waterloggedDon't think so.

[Project Ski]

@125 with tubbies, stering, motormounts and hardware you are probably nice and dry

[WFO Speedracer]

I don't want to know on mine since I sank it twice.:Thinkingof_::Thinkingof_:

[shawn_NJ]

I didnt weigh any of my hulls yet.... but I took well over 30+ lbs of wet foam out of one of my dead hulls!!!!

[cattledog]

thanks i was just concerned because my cooling line is cracked in hull , so its not waterlogged that much i even took one side of turf and cut into floor tray just to see, it wasnt to wet and other area dry , so i am going to use the other lines, two caps on the broken line, seal everything up, bendix coming this week put it back togeher, i am thinking this thing froze and line cracked. when i put ar thru cracked line i got air leaking from driveshaft tube and around the seal below driveshaft bearing holder going to seal this area real good.

[Nefarious]

Just weighed mine: 122# stripped minus hull braces