what carb to use on stock 650 motor

[cattledog]

putting tubbies on tomorrow, list of my parts for ski stock motor good compression, factory pipe just got new headpipe sweet,jetsport exhaust manifold,maybe shave head,15 skat trak prop, it came with d g intake manifold with 38mm opening it was not installed just laying in hull, it also came with 38 mm carb off a 650 sx looks brand new it pulls from bottom. should i use this carb or go different carb and intake

[shawn_NJ]

Do you have the manifold for a 44sbn? If not I would just run what you have. Its not like your not going to drop a 750 in there next year and need a bigger carb.....LOL

[cattledog]

hey shawn just might keep the set i will know next week after paint, sanding and bodywork is not my thing i love to put things together and make them run and yes i have been looking for 750 and canadian money is high which is a big bonus. i dont have 44mm intake or i would get 44mm carb. maybe i will buy one in floridia lots of cheap skis their that people dont even advertise, but can be found in local papers

[cattledog]

shawn did you use pilot drill on tubbie screws, on one of yours post u had trouble with screws that came with set

[shawn_NJ]

The screws SUCK that blowsion sent. I went out and bought a bunch of one size up SS screws in every length that was in the blowsion set. I drilled the holes out one at a time working from the rear of the tubbie forward, while screwing each drill hole in before moving to the next! Make sure you do this! The tubbie flattens out ALOT. Read up on peoples tubbie installs on here because there were some real nice installs. Mine is subpar, but got the job done.

[cattledog]

yes i have looked at others people threads i am going to use gassems 40 inches from rear of ski do u know the measurement of back of your ski to rear of tubbie

[shawn_NJ]

I can check for you on saturday (first time I will be able to get to the storage place) but I assume you'll have them on by then....lol

[cattledog]

thanks shawn have been seeing all the pictures of x2's with tubbies and they are in roughly the same spot, are you using bilge switch on handlebar