61x intake

[waxhead]

Any one have a pic of a wetjet manifold for the 61x engine

[Mile9c1]

I can take some tomorrow. It's tits.

[waxhead]

awesome thanks
i am wondering if there would be enough of a demand on them to actually make some of them

[Mile9c1]

I don't think there would be, you can still buy them new for around $120.

Make a billet Lamey cylinder with an exhaust bridge. That would be killer.

[waxhead]

Are you talking about something that would look like this
its just the start of a drawing so far

http://show.imagehosting.us/show/1072779/0/nouser_1072/T0_-1_1072779.jpg (http://www.imagehosting.us/index.php?action=show&ident=1072779)

I havent done the exhaust ports in from the side yet
its looking like it will be to hard as you need a 4 axis mill
but its being looked at

http://show.imagehosting.us/show/1072781/0/nouser_1072/T0_-1_1072781.jpg (http://www.imagehosting.us/index.php?action=show&ident=1072781)

[butti]

that looks very adaish:eek: please keep us informed:D

[waxhead]

its just a generic drawing at the moment
dont worry i will keep every one informed
i have to see paul anf figure out the heights and the angles of the transfers yet
as well as i have to do the spacing on the transfers on the bottom
this was just a hack job to start with
but i have a few drawing that are further along i just dont want to post them yet